Q What flooring pack sizes are available?
A 18mm board – 68 boards per pallet, 1.3 metric tones per pallet
22mm board – 56 boards per pallet, 1.3 metric tones per pallet

Q What are the standard Weather Dek densities?
A 18/22mm flooring is normally manufactured at 685-690 kg/m_
Weight per board 2400 x 600 - 18mm 17.75 kg – 22mm 21.7 kg

Q What do you recommend to remove Weather Dek adhesive?
A Weather Dek hand wipes and Weather Dek gun cleaning fluid are both available from local stockists.

Q To what standards do Puhos boards conform?
A BS EN 312, CE Marked, PEFC certified. See website under ‘Certification’

Q Where does board identification appear?
A Top of each flooring panel

Q What are the maximum joist centres for Puhos panels?
A 18mm maximum 450mm centres - 22mm maximum 600mm centres

Q Can Weather Dek flooring be laid in the rain?
A Not recommended

Q Can Weather Dek flooring be laid if joists are wet or frozen?
A Yes – provided there is no standing water

Q Can house builders tile or carpet directly on to Puhos flooring?
A This is common practice. However, it is not recommended in new build properties and boards should always remain dry to avoid movement and possible damage to the overlay.

Q In floating floor applications, should the vapour barrier be placed above or below the insulation layer?
A Either is common practice. Puhos preference is to place above the insulation to avoid possible membrane damage through direct contact with the concrete floor.

Q Is it necessary to provide perimeter noggins with Puhos flooring?
A Yes. This is an NHBC requirement.

Q Do board joints always need to be supported?
A No. However, any short ends that do not fall on a joist or I-beam flange, regardless of board thickness or joist centres, do require support.

Q What can be done after the wrong thickness of boards has been inadvertently laid over joist centres?
A First preference is to remove boards and replace with correct specification. However, with the approval of NHBC, a plywood overlay can be considered as a solution and can avoid inconvenience to the house owner of relaying the floor.

Q How many accessories are needed per pallet of Weather Dek?
A See table below

Accessory
18mm
22mm
Pack Size
Full Load
Wdek Edge Tape
16 rolls per pallet
12 rolls per pallet
30
18 = 10 packs
(25m x 50mmm)
22 = 8 packs
Wdek Edge Tape
9 rolls per pallet
7 rolls per pallet
30
18 = 6 packs
(Using Fast Fix System)
22 = 5 packs
Tape Applicator
1
Wdek Edge Jointing
1 tube per 30 boards
1 tube per 30 boards
8
18 = 7 packs
D3 Adhesive
22 = 6 packs
Wdek Nails - 5kg box
1 box per pallet
1 box per pallet
1
18 = 18 boxes
(Annular ring shank - 55mm)
22 = 18 boxes
Wdek Fast Fix
1 tube per 12.5 square metres
1 tube per 12.5 square metres
10
18 = 14 packs
22 = 12 packs
Wdek Fast Fix Applicator Gun
1
Wdek Replacement Nozzles
10
Wdek Fast Fix Hand Wipes
150